The Components of Belt Hangers

Release time:2013-10-07      Source:admin      Reads:
The belt hanger essentially consists of four main components: the frame, chape, bar, and prong. The oldest Roman buckles are of a simple "D"-shaped frame, in which the prong or tongue extends from one side to the other. In the 14th century, buckles with a double-loop or "8"-shaped frame emerged. The prongs of these buckles attach to the center post. The appearance of multi-part buckles with chapes and removable pins, which were commonly found on shoes, occurred in the 17th century.
 
The frame is the most visible part of the buckle and holds the other parts of the buckle together. Buckle frames come in various shapes, sizes, and decorations. The shape of the frame could be a plain square or rectangle, but may be oval or made into a circular shape. A reverse curve of the frame indicated that the whole buckle was intended to be used for securing a thick material, such as leather. This reverse curve shape made it easier to thread the intended thick material end over the bar. But the shape of the frame is not limited to simply squares and ovals, the decoration of the frame itself defines the shape it will turn out to be. Since the frame is the largest part of the belt hanger, any and all decorations are placed on it. Decorations range from wedged shapes, picture references to people and animals, and insignia of a desired organization.
 
The part of the frame that strap goes through prior to putting the tongue/prong through the hole is often referred to as the 'end bar'. The 'center bar' holds the tongue and the part (if present) that holds the tip of the strap in place is called the 'keeper' or 'keeper bar' these terms are used when additional information is needed to describe a belt hanger for measurements or design. Note that if an a separate piece of leather or metal is attached to the strap for holding the tip of the belt/strap in place that is sometimes also called a 'keeper'.

鄂公网安备 42011202000787号